Forklifts and loaders for ports and terminals
Port work is measured in cycles and tonnage, not in pallets. The machine is chosen on duty cycle, berth width and salt exposure.
What decides the machine here
Duty cycle
Container stuffing runs the hydraulics continuously. A truck rated for intermittent duty will overheat by mid-shift; the oil cooler is the specification that matters.
Salt and humidity
Standard paint fails at the mast and the chassis seams within two years. Specify a marine paint schedule and stainless fasteners.
Ground
Concrete aprons take solid tyres; intermodal yards with broken surface need pneumatic. The same truck is not correct for both.
Load density
Steel coil and paper pulp are dense loads at short centres. Check residual capacity at the actual load centre, not the rated plate figure.
Models that work in this environment
The first four sizes of each relevant range. Every one links to its full specification.
| Range | Model | Capacity | Bought for |
|---|---|---|---|
| Diesel Forklift | CPC(D)15 | 1.5 t | 1. |
| Diesel Forklift | CPC(D)20 | 2 t | 2. |
| Diesel Forklift | CPC(D)25 | 2.5 t | 2. |
| Diesel Forklift | CPC(D)30 | 3 t | 3. |
| Electric Wheel Loader | 06EV | 400 kg | 400 kg, lithium iron phosphate. |
| Electric Wheel Loader | 1200EV | 1200 kg | 1,200 kg. |
| Electric Wheel Loader | 1500EV | 1500 kg | 1,500 kg. |
| Electric Wheel Loader | 2000EV | 2000 kg | 2,000 kg. |
| Electric Forklift | MS-05 | 0.5 t | Three-wheel, 0. |
| Electric Forklift | MS-08 | 0.8 t | Three-wheel, 0. |
| Electric Forklift | MS-10 | 1 t | Four-wheel, 1. |
| Electric Forklift | MS-15 | 1.5 t | Four-wheel, 1. |
The mistake we see most
Comparing hourly fuel cost while ignoring tyre life. Port tyres on abrasive concrete are often the largest single maintenance line, and a cheaper truck with a lighter axle eats them faster.
Describe the site, not the machine
Ground surface, aisle or gate width, lift height, hours per shift, destination port. We answer with the model and the reason.